Product Overview
The Re-Verber-Ray BVP-4 is a 4 in. double-wall B-vent pipe section, 60 in. long, weighing approximately 10 lbs. In the vent system, this pipe section carries hot flue gases from the heater's vent connection through the combustible wall or roof penetration and out to the outdoors, keeping the flue gas path sealed and clear of combustible materials as the manufacturer's venting design requires.
Fits the Re-Verber-Ray UH-60 to FA-125 unit heater series (4 in. vent connection) and the DSR series patio heaters; see Fitment below for the full model range.
Ships as a standalone pipe length, ready to connect into the heater's vent run alongside the other B-vent fittings and caps the installation calls for.
When replacing this part, shut off the gas supply and disconnect power to the heater before beginning work, and have a qualified technician verify the vent connection and heater operation against the installation sheet once the new section is installed. See the UH & FA Series venting accessories sheet for the full 4 in. venting parts list.
Specifications
| Diameter | 4 in. |
| Length | 60 in. |
| Type | Doublewall B-vent |
| Weight | 10 lbs. |
| Application | Used for penetrating through combustible wall and/or roofs |
Cross-Reference & Fitment
| Alternate part numbers | 4BV60 |
| Fits | UH-60 series unit heaters, UH-75 series unit heaters, FA-100 series unit heaters, FA-125 series unit heaters, REV series heaters, MP3 series heaters, HL3 series heaters, DX3L series heaters, DET3 series heaters, DES3 series heaters, HL2-SB/-SS series heaters, DX2-SB/-SS series heaters, CL3 series heaters, CX3 series heaters, SV series heaters, HLV series heaters, UH-60N to FA-125N, DSR series patio heaters |
